Quanta-Flame Primary Control

Now CSA Approved!

The New Technology direct replacement
for the Honeywell RA890 Series.

Microcomputer controlled Primary Burner
Management Control System

At last an upgrade for the industry standard - RA890F / RA890G - with only ONE part to change.

The Quanta - Flame 5004-890 is just what the technicians have been waiting for - the new technology equivalent of the Honeywell 890 series. This time-saving control uses existing Honeywell sub-bases, flame rods, and UV scanners, but with significant upgrades, including an LED display and microprocessor control.

It's expensive technology brought down to earth, in an affordable and efficient control that lets you troubleshoot more burners without spending a fortune on parts.

No Expensive Upgrades

Uses Q270 sub-base and existing Honeywell UV sensors and flame rods
No rewiring necessary
No special scanners needed.

More Flexibility

Selectable trial for ignition: 3, 5, 10 or 15 seconds
Selectable interrupted or intermittent (non-interrupted) pilot
Selectable recycle or non-recycle modes
Selectable flame systems: ultraviolet or flame rod sensors
Isolated 10 Amp alarm circuit

Ease of Troubleshooting

Direct replacement of Honeywell RA890F and RA890G
Optional plug-in diagnostic display installs easily in the top of the control
Microcomputer control simplifies fault and relay testing
Test mode for pilot flame adjustment
Operational status check: seven front-mounted LED indicators

Contact Us Directly:

Toll Free: 1-800-780-3776
Int'l Phone: 770-957-9599
Int'l Fax: 770-957-9563
E-Mail: Email Your Request

Mailing Address: Power Plus International
143 McDonough Parkway
McDonough, GA 30253